When the update finishes, a message will be displayed. The info LED will blink during the update.Ĩ. Transferring and updating the firmware will start. Click "Update" and enter the LinkStation's admin password.ħ. Select the LinkStation to update if multiple LinkStation are connected.ĥ. When a LinkStation is detected, an update window will open.Ĥ. Extract the downloaded file and run ""LSUpdater.exe". Also, stop or exit any firewall software.ģ. Then they will be on the same subnet and the updater will work properly.Ģ. In this case, reconfigure the LinkStation's IP address and subnet mask to Then the updater will _not_ work properly. The last number of the IP addresses should be different.įor example, if the IP address and subnet mask of the computer areĪnd the IP address and subnet mask of the LinkStation are The subnet masks should be the same and the first three numbers of the IP addresses should be the same. Connect the LinkStation properly and configure the LinkStation and a computer to run the updater on the same network subnet. To mount them, unplug and then reconnect them.ġ. USB drives are not mounted automatically after a firmware update. You will receive a message when the update is finished. Do not turn the unit off until the update is finished. Please consult your local technical support representative if you experience any problems caused by this firmware update. Fixed a bug where files were not accessible via WebAccess if UPnP is enabled for the WebAccess settings. Modified so that SMB protocol versions to be enabled become selectable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |